If the fuse is good you have a wiring or switch problem. 2 Key ON PTO switch ON steering controls at.
If you have already done this I recommend checking the fuse.
How to test lawn mower pto switch. YouTube has a gajillion videos on that. Lift the utility vehicle up with a floor jack. Remove the switchs plug and test it for battery voltage with the meters voltmeter.
1 Key ON and seat occupied. With the battery connected and engine turned off place the negative alligator lead of a test light to a ground source. Now the way we test this type of switch is to turn the switch in the off position once you have got your key switch inserted into the lawnmower switch and turn it into the off position.
Start the engine and let it warm up. Place the negative voltmeter lead on a good engine source. Set the meter to measure ohms and check the switch for continuity.
Look for the in-line fuse between the electrical wiring harness from the lever switch to the PTO clutch assembly under the deck. If so check this video out I will try and helpI have found a NEW voltmeternot the Fl. HOW TO TEST a RIDING LAWN MOWER IGNITION SWITCH KEY SWITCH.
Look for the in-line fuse between the electrical wiring harness from the lever switch to the PTO clutch assembly under the deck. Remove the wires connected to the switch. Step by StepToday Ill be showing you how to Test a Riding Lawnmower Safety SwitchFollow the steps in the video youll be back cutting your lawn in no ti.
The PTO switch is turning the power off correctly if. The PTO switch provides power to the PTO clutch. Activate the PTO clutch lever and look for the bulb to illuminate from the test light.
Take the negative lead from the volt meter and clip it to the other tab. TESTING a LAWNMOWER KEY SWITCHMusic by. Terminal 85 should show a ground under the following conditions.
The fuse is located behind the dash. First make sure the engagement lever is down or the PTO button is pushed in and the brake pedal is fully depressed or the tractor will not attempt to turn over. Place the negative voltmeter lead on a good engine source.
Place the probe of the test light inside the wire connector attaching it to the red lead that leads to the PTO clutch. Use a multimeter to diagnose the clutch switch and circuit. Put the DVOM on Ohms.
Lift the utility vehicle up with a floor jack. Test the PTO switch by trying to start the engine by putting the key back in the ignition and turning it all the way to the START position. If the volt meter reads 12 volts replace the electric PTO.
Is the problem the ignition switch. To determine if the switch is defective use a multimeter to test it for continuity. How to Test a PTO Clutch.
If the PTO switch is defective replace it. Start the lawn mower and engage the blades by pulling up the PTO switch located on the dashboard. As a result the clutch wont engage and the lawn mower blades wont rotate.
How to Test a PTO Clutch. On a good switch the meter should display infinity with the switch open and the pedal out not depressed. If the switch is defective it may not supply power to the PTO clutch.
Do your mower blades fail to engage when you pull the PTO switch up. Once you hear the clicking noise proceed to the next step and youre going to put your digital multimeter. Terminal 85 must be checked with one lead of the volt meter attached to a battery positive source and the other test lead touching the 85 terminal.
Start the engine and let it warm up. Touch the DVOM leads together to see how it looks going from high to low.
Pin On Diy Small Engine Outdoor Equipment Maintenance And Repair
Yes You Need To Winterize Your Lawn Mower Here S How Lawn Mower Lawn Mower Maintenance Lawn
0 Comments